Designed and made in the UK from 100% recycled black polypropylene.
Following the tried and tested rear Mudhugger design, will fit most bike frame seat stays (with angles approx 40-55 degrees) and designed for tyres up to 50mm wide.
The Rear GravelHugger is designed to be attached to the bike (disc brakes only) with zipties as these afford the most secure way to fitting. See fitting vid below, fitting the new GH is the same as our tried and tested MTB Rear Mudhugger :)
PLEASE ENSURE YOU USE THE HELITAPE PROVIDED WITH THE REAR MUDHUGGERS. INVISIFRAME OR ELECTRICAL TAPE ARE NOT SUFFICIENT TO PROTECT YOUR BIKES PAINT AND FRAME.
The Rear GravelHugger can also be attached utilising hook and loop straps (sold separately) making removing and refitting quicker and reduce single use plastic waste.
Helitape is supplied to protect the seat stays where the GravelHugger sits on the seat stays, ensure you use this tape, invisframe, electrical tape or similar are not sufficiently thick to protect your bikes paint and frame.
Suitable for 700c and 650b wheels Max tyre width 50mm (depending on wheel/tyre combination).
Weight approx 150g - Length 560mm -Width 55mm
Designed, made and packed in the UK from 100% recycled polypropylene, which of course can be recycled again.